B- Programming The Remote Control; C- Fitting - Eurocave INOA 25 Manuel D'installation

5 - I
- Programming the remote control
Where placing the remote control outside the cellar, having connected the external sensor, it is essential to reprogramme the unit
- To turn on the remote control, press and hold down the
- First press and continuously hold down the
lines appear.The model number is then displayed and flashes.
- Press .
- The screen appears indicating IN (IN= internal installation). Press the
- The display appears indicating OUT (OUT= external installation). Press
- The pictogram appears. Press
- The screen appears. Press
- The pictogram appears. Press
- .appears. Press
- The pictogram appears. Press
- The screen appears, then
If you wish to reprogramme the remote control for an internal sensor, disconnect the wired sensor and reprogramme the remote control in internal mode
(IN) by repeating the first two steps described in the paragraph above (see 5-III-b p.11):
The 2nd screen displays
confirm.
Then repeat the same steps, as indicated in the above paragraph (see 5-III-b).

c- Fitting

- Fit the remote control and sensor using the screws and pegs supplied (see diagram on page 9, chapter II).
- Place the sensor inside the cellar.
- Place the sensor as close as possible to the bottles
N.B.: the sensor has a range of 3 metres.
NSTALLING THE REMOTE CONTROL
key for about 8 seconds until the
key, at the same time press and continuously hold down the
.
.
.
.
.
.
indicating OUT (OUT= external installation). Press the
indicator goes off.
.
key to change to OUT external mode.
to confirm.
key to change to IN internal mode. Press
key for several seconds until three
to
10
GB