Installing The Conditioner; I- General Points - Eurocave INOA 25 Manuel D'installation

Masquer les pouces Voir aussi pour INOA 25:

Mode d'emploi (44 pages)

Mode d'emploi (24 pages)

Table des Matières

Les langues disponibles

I - General points

- If the power lead is damaged, it must be replaced by a qualified electrician.

- Never damage the appliance's refrigerating circuit.

Your conditioner's power lead is supplied without a plug. "Fitting a power plug or connecting the conditioner to a junction box must be carried out by a

qualified electrician.

In all cases, connection of your conditioner must be carried out on an earthed socket to prevent any risk of electric shock.

230V-13A* earthed power outlet with differential circuit breaker (30mA*) protected by a fuse.

*not valid for some countries

IMPORTANT : any electrical work must be carried out by a qualified electrician. Power outlet not valid for some countries.

Electric connection must be carried out by means of a device to ensure isolation from the mains system. The

isolating device should open all of the contacts of all the poles ensuring complete disconnection in line with the

conditions in over-voltage category III. Installation must be carried out in compliance with national installation

regulations.

• Positioning your conditioner:

The conditioner produces cold air inside the cellar and expels hot air outside (see diagram A).

- Do not install the conditioner facing the door of the room (risk of condensation on the door joints).

- Do not place the external section of the conditioner above a source of heat.

- For insulation reasons, there must be no windows or bay windows in the room to be conditioned.

- No piped hot water must pass through the room to be conditioned (e.g. under-floor heating).

- Is it not better to state that pipes with hot water must be insulated so that there is no heat loss?

- The exterior of the conditioner must not be located in an area subject to atmospheric exposure.

- No heat-producing appliance must be located in the area to be conditioned (e.g. refrigerator, radiator, boiler).

- Do not obstruct the air entry and exit points.

- Never place a container or object containing liquid on top of the conditioner.

- The room where the hot air is expelled must, ideally, be approximately twice as large as the wine cellar and well

ventilated so that the hot air can be properly expelled.

- Wait 48 h before plugging in so that the fluids in the internal circuits can settle.

- Never connect several conditioners to a multi-socket.

• Recommendations:

- Fit your conditioner as close as possible to the ceiling in order to ensure uniform dispersal of cold air in the

cellar.

- We recommend that you leave a space of 200 mm between the ceiling and conditioner housing to make it easier

to fit the appliance onto its base.

- Air outlets (hot and cold) must not be obstructed by any obstacles (minimum distance: 1500 mm).

Direct the cold air outlet so it is facing the bottles (see diagram D).

• Installation: (see B diagrams)

The conditioner was designed to be completely modular and adapt to any type of cellar.

You can, amongst other options, install it either outside or inside your cellar, position it close to the floor (fixed to the wall) or at a height (we recommend,

however, installing it at a height for improved air convection).

Additionally, hot air can be expelled from different angles (to be specified when ordering): facing forwards, right or left.

You also have the option of expelling hot air outside the room by way of extractor piping (standard piping, 160 mm in diameter, not supplied).

Finally, you can choose to fit the conditioner onto a door.

Conditioner housed inside the cellar

with extraction facing forwards /

aesthetic front panel on the outside

Conditioner housed outside the cellar

with extraction on the left side /

aesthetic front panel on the inside.

4 -