Managing Multiple Handsets; Setting Up An Additional Handset - Topcom BUTLER 4502 TWIN Manuel D'utilisateur

6

Managing multiple handsets

6.1

Setting up an additional handset

You only need to register a 2nd handset in case your 2nd handset does
not link with the base anymore or when you have bought a new one!!!
You can register new handsets on the base if these handsets support the DECT GAP
protocol.
The base can support a maximum of 5 handsets. If you already have 5 handsets, and you
wish to add another one or change one handset, you must first delete a handset, then
associate the new handset.
To register any handset, the base must be put into a special registration mode:
1. Press and hold the paging key
2. The base will then emit a beeptone. The base is now ready to register a new handset.
You have 90 seconds after pressing the button to register a new handset.
After putting the base into registration mode, start the procedure on the new handset:
6.1.1 if your additional handset is a Butler 450x
3. Enter the menu by pressing
4. Select REGISTER using the up
5. Press OK
6. Select REG BASE using the up
7. Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.
8. Enter the Base PIN code (0000 by default )
9. Press OK. The handset will start searching for the DECT base
10. If the handset has located the base, it will display the base identification number,
validate the base registration by pressing OK or stop by pressing
11. If the handset does not locate the base, it will return to the standby mode after a few
seconds.
12. Try again by changing the base number and check that you are not in a environment
where there is interference. Move closer to the base.
6.1.2 if your handset is another model
After starting the registration procedure on the base, refer to the handset manual to find out
how to register the handset. The handset must be GAP compatible.
The icon and the text 'NOT REG' flashes on the display when the handset is not
associated with the base.
When a handset is associated with a base, it is attributed a handset number by the base. It
is this number that is displayed on the handset after the name and must be used for internal
calls.
Topcom Butler 4502/Twin/Triple/Quattro
of the base for 6 seconds.
/OK
and down keys
and down keys
Topcom Butler 4502/Twin/Triple/Quattro
.
21