Flash Time Duration; Managing Multiple Handsets; Adding A New Handset - Topcom BUTLER E450 Manuel D'utilisateur

7.5

Flash time duration

Press the flash key 'R' (key 7 - picture 2D Handset) to use certain services on your external line
such as "call waiting" (if your phone company offers this feature); or to transfer calls if you use a
telephone exchange (PABX). The Flash key 'R' is a brief interruption of the line. You can set the
flash time to 100ms or 250ms
8

Managing multiple handsets

8.1

Adding a new handset

Only needed when you have deregistered a handset or when you bought a new one.
You can register new handsets on the base if these handsets support the DECT GAP protocol.
The base can support a maximum of 5 handsets. If you already have 5 handsets, and you wish to
add another one or change one handset, you must first delete a handset, then associate the new
handset.
Putting the base into registration mode:
Register the new handset:
If your additional handset is a Butler E450
4 5 6
GHI JKL MNO
4 5 6
GHI JKL MNO
1 Enter the menu.
2 Select "SETUP" and confirm.
3 Select "RECALL" and confirm.
4 Choose "RECALL1" for short flash time (100ms) or "RECALL2" for long
flash time (250ms) and confirm.
1 Press and hold the paging key on the base for 6 seconds. The base will then
emit a beep tone.
The LED on the base will start to blink for 90 seconds. During that time, the
base is ready to register a new handset.
2 Enter the menu.
3 Select "REGISTER" and confirm.
4 Select "REG BASE" and confirm.
5 Enter the number of the base to be associated with the handset (1-4) and
confirm. (The flashing numbers are already in use.)
6 Enter the Base PIN code (0000 by default) and confirm.
The handset will start searching for the DECT base. If the handset has located
the base, it will display the base identification number.
7 Confirm or stop.
If the handset does not locate the base, it will return to the standby mode after
a few seconds. Try again by changing the base number and check that you are
not in an environment with interference. Move closer to the base.
Managing multiple handsets
17