Maytag MFF2558FEZ Manuel D'utilisation page 16

Turbidity
Chlorobenzene
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.70 gpm (2.65 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to
71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters) with PID, 100 gallons (379 liters) without PID.
The compounds certified under NSF 401 have been deemed as "emerging compounds/incidental contaminants." Emerging compounds/
incidental contaminants compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace
levels, these compounds can affect the public acceptance/ perception of drinking water quality.
� It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised. Property damage can occur if all
instructions are not followed.
� The disposable cartridge must be changed at least every 6
months.
� Use replacement filter UKF8001, Part # EDR4RXD1/
EDR4RXD1B. 2018 suggested retail price of $49.99 U.S.A./
$49.95 Canada. Prices are subject to change without notice.
� The filter monitor system measures the amount of water that
passes through the filter and alerts you when it is time to replace
the filter. To learn how to check the water filter status, see "Using
the Controls" or "Water Filtration System" in the User
Instructions or User Guide.
� After changing the water filter, flush the water system. See
"Water and Ice Dispensers" or "Water Dispenser" in the User
Instructions or User Guide.
� These contaminants are not necessarily in your water supply.
While testing was performed under standard laboratory
conditions, actual performance may vary.
� The product is for cold water use only.
� The water system must be installed in compliance with state and
local laws and regulations.
*Class I particle size: >0.5 to 1 um
†Based on the use of Cryptosporidium parvum oocysts
††Fibers greater than 10 um in length
NSF is a registered trademark of NSF International.
®
16
11 NTU ± 10%
2.0 ± 10%
0.5 NTU
0.1 mg/ L
� Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts. EPA Est.
No. 69625-CT-001
� Refer to the Warranty for the Manufacturer's limited warranty,
name and telephone number.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
� Your water filtration system will withstand up to 120 pounds per
square inch (psi) water pressure. If your water supply is higher
than 80 psi, install a pressure reducing valve before installing
the water filtration system.
98.8%
>99.9%
Potable City or Well
30 psi - 120 psi (207 kPa - 827
kPa)
33°F - 100°F (0.6°C - 37.8°C)
0.70 GPM (2.65 L/min.) @ 60
psi. (413.7 kPa)
98.2%
99.9%