Display Switch-Off / Reset / Test Program / Firmware Version; Cleaning The Unit; Specifications - IMG STAGELINE LED-162RGBW Mode D'emploi

5.4 Display switch-off / reset /
test program / firmware version
Use the menu item
ing functions:
Submenu
Function
item
Display will be switched off 30 sec. after the last
LEDs
press of a button:
To reset the unit to its factory settings:
DMX channels: 4, start address: 001,
speed for all functions: 80,
Reset
brightness R, G, B, W: 255 each,
display switch-off: on ( )
Test program: To run all functions one after the
Test other and to switch on all LEDs
To indicate the firmware version
Vers(ion)
Fig. 10 Functions of the menu item
1) Press the button MENU repeatedly until
appears on the display .
2) Press the button ENTER and then use the
button UP or DOWN to select the submenu
item desired .
3) Press the button ENTER to activate the
function . For the display switch-off function
( ): Use the button UP or DOWN to acti-
vate ( ) or deactivate (
4) Use the button MENU to return to the menu
item and then press the button (repeat-
edly) to go to the operating mode desired .

6 Cleaning the Unit

Clean the plastic lenses at regular intervals de-
pending on impurities . This is the only way to
ensure that light will be emitted at maximum
brightness . Before cleaning, disconnect the
mains plug from the socket. Only use a soft
clean cloth and a mild detergent .
For cleaning the other parts of the housing,
only use a soft dry cloth . Never use any chemi-
cals or fluids; they may leak into the light effect
unit and damage it .
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
to carry out the follow-
= yes, = no
) it .
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®

7 Specifications

Light source
Light pattern: . . . . . . . . . 4 LEDs, 3 W
Running light: . . . . . . . . . 16 white LEDs, 0.5 W
DMX
Data protocol: . . . . . . . . . DMX 512
Number of channels: . . . . 4 or 1
Connections:. . . . . . . . . . XLR, 3 poles
Pin configuration:. . . . . pin 1 = ground
Power supply: . . . . . . . . . . 230 V~/50 Hz
Power consumption: . . . . . 40 VA
Remote control battery: . . . 3 V lithium button cell
Dimensions: . . . . . . . . . . . 190 × 260 × 180 mm
Weight: . . . . . . . . . . . . . . . 2 kg
Accessories supplied: . . . . . remote control,
Subject to technical modificat
(red, green, blue, white)
pin 2 = DMX−
pin 3 = DMX+
type CR 2025
mains cable
15