ABB PVS800 Manuel D'exploitation page 14

10
No. Name/Value
40.14 RT U/Un DELTA t2
0...[40.13] ms
40.15 RT U/Un DELTA t3
[40.13]...8388608
ms
40.20 TRP VOLT PEAK
0...200%
40.21 TRP VOLT LEV
0...[40.20]%
40.22 TRP VOLT TIME
0...8388608 ms
40.23 TRP VOLT SEL
POS SEQ
RMS VOLTAGE
40.24 RMS VOLTAGE
CALC
OFF
PHASE VOLT
MAIN VOLT
Update notice
FbEq Description
1 = 1 ms Defines the time (t2) when the
to rise from level 2 to level 3.
Time 2
1 = 1 ms Defines the end time (t3) of the extended RT area. Fault
LOST (32A1) is generated if
returned above
Time 3
1 = 1% Instant trip level for high grid voltage. If the level is exceeded, the
fault HIGH UAC PEAK (32A4)
Peak trip level
1 = 1% Trip level for high grid voltage level. If the voltage remains above
this level for longer than the time defined by
TIME, the fault
Trip level
1 = 1 ms Defines the time for high voltage level monitoring (parameter
TRP VOLT LEV).
Time for high voltage level monitoring
Defines the source for high grid voltage monitoring.
0
01.11 MAINS VOLTAGE
positive component
measured
calculated
1 Highest RMS voltage if
ON.
Note: Parameter
BOARD ENABLE
Enables/disables RMS voltage calculation.
0 RMS voltage calculation is disabled.
1 RMS phase voltage calculation is enabled.
2 RMS main voltage calculation is enabled.
RT NET LOST (32A1)
01.11 MAINS VOLTAGE
[40.10 RT U/Un LEVEL1] + 5%.
is generated.
HIGH UAC LEV (32A5) is generated.
40.01
ON
OFF
OFF
40.02 NAMU BOARD ENABLE
01.11 MAINS VOLTAGE
is set to OFF.
Def.
trip limit starts 600 ms
RT NET 20000 ms R
has not
130%
120%
40.22 TRP VOLT
40.21 20 ms
RMS
VOLTAGE
40.02
ON
ON
OFF
is set to
is used if 40.02 NAMU
OFF
T
R
R
R
R
R
B