Electrolux SB225 Notice D'utilisation page 11

Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
There is too much frost
and ice.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the
refrigeration is too high.
The temperature in the
freezer is too high.
The appliance does not
operate.
Possible cause
During the automatic
defrosting process, frost
defrosts on the rear plate.
The water outlet is
clogged.
Products prevent that
water flows into the water
collector.
The melting water outlet
does not flow in the
evaporative tray above the
compressor.
Products are not wrapped
properly.
The door is not closed
correctly.
The Temperature regulator
may be set incorrectly.
The Temperature regulator
may be set incorrectly.
The Temperature regulator
may be set incorrectly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
Products are too near to
each other.
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
ENGLISH
Solution
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Wrap the products better.
Refer to "Closing the
door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the product tem-
perature decrease to
room temperature before
storage.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
11