Marmitek SPLIT 812 Mode D'emploi page 6

6. FAQ
No (or bad) image and sound
If you see a bad image or no image at all after connecting the HDMI splitter,
try to establish what the problem is by connecting your devices, one by one,
to your screen (TV, monitor or projector). This will allow you to establish
whether the problem lies in the HDMI sources, the HDMI cables, the HDMI
splitter or the screen. HDMI equipment that has not been tested and
certified by ATC (Authorized Test Centers) may cause image and sound
problems.
Check whether the Split 812 power adapter is connected and plugged
x
in;
Only use High Speed HDMI® certified cables for the best picture and
x
sound quality;
Do not use HDMI cables that are longer than specified in the technical
x
data;
Check whether the HDMI cables and/or connectors are damaged;
x
Both the HDMI source as well as your screen must fully support HDMI;
x
Check whether your HDMI sources and screen support HDCP (High-
x
bandwidth Digital Content Protection).
No proper 3D picture
Check whether the HDMI source has been set to 3D and/or that this is
•
set to automatic.
Both the HDMI source as well as the HD screen must support the same
•
3D formats.
Check whether the proper 3D picture is reproduced by directly
•
connecting the HDMI source to the screen with an HDMI cable.
Do you have a question that has not been answered here? Then have a
look at www.marmitek.com
6 © MARMITEK