Operation And Function; Controls; Configuring The Gsm Module - Wilo DrainAlarm/-GSM Notice De Montage Et De Mise En Service

OPERATION AND FUNCTION

5.4.11. Display of operating readiness
The LEDs in the housing cover signal proper func-
tion as follows.
DrainAlarm
Symbol Colour
LED is lit up: Mains voltage is present,
Green
battery is charging
DrainAlarm GSM
Symbol Colour
LED is lit up: Mains voltage is present,
Green
battery is charging
GSM module: LED is lit up
Green
Ready for operation after 2 minutes
GSM module: Status LED
Continuous flashing: Start procedure
Yellow
Is lit up: Connected to the mains
Flashes twice: SIM card not available
6. Operation and function
This section contains all information on operating
the alarm switchgear and how it functions.
DANGER due to electrical voltage!
When working on the uncovered alarm
switchgear, there is a risk of fatal electric
shocks. Only operate the alarm switchgear
with the cover closed!

6.1. Controls

After successful mains connection, the alarm
switchgear operates fully autonomously. If an
alarm is signalled, only the acknowledgement
button must be pressed. The current operating
status is indicated via LEDs.
6.1.1. Buttons
Symbol
Acknowledgement button
off
This button is used to acknowledge alarm signals:
the yellow LED goes out and the buzzer stops
6.1.2. LEDs
Symbol Colour
LED is lit up: Mains voltage is present,
Green
battery is charging
Installation and operating instructions Wilo DrainAlarm/-GSM
Description
Description
Description
Description
Symbol Colour
Alarm signal:
LED is lit up: Signal present at terminal
6 and 7 or mains voltage missing
Red
LED goes out as soon as the signal at
terminal 6 and 7 is no longer present
and the mains voltage is present again.
Alarm signal:
LED is lit up in parallel to the red LED
Yellow
LED goes out as soon as the alarm
signal was acknowledged.
GSM module: LED is lit up
Green
Ready for operation after 2 minutes
GSM module: Status LED
Continuous flashing: Start procedure
Is lit up: Connected to the mains
Yellow Flashes once: Modem does not respond
Flashes twice: SIM card not available
Flashes three times: GSM signal too
weak
1
GSM module: When the LED lights up,
Green
the respective relay is connected
2

6.2. Configuring the GSM module

After installation, the GSM module in the DrainAl-
arm GSM alarm switchgear must be configured via
software. For this purpose, the alarm switchgear
must be connected to the PC via a mini USB cable
and configured via software.
6.2.1. Mobile phone plan and SIM card
The alarm switchgear starts automatically
after the electrical connection is established. If
configuration is incorrect, text messages can be
sent automatically. This can result in high costs.
To avoid this, always comply with the following
points:
• Do not insert the SIM card until the device has
been configured correctly and in full.
• Choose an appropriate mobile phone plan with
transparent test message costs.
6.2.2. System requirements
Minimum re-
Description
quirement
IBM compatible PC with x86 or x64
PC system
processor
RAM 256 MB
Hard drive space 10 MB
CD-ROM Required for installation from CD
1024 x 768,
VGA
256 colours
USB standard* 2.0
USB connection Mini-USB
English
Description
Recommended
requirement
512 MB
10 MB
1280 x 800
32 bit
2.0
Mini-USB
25