Meister EH600M Traduction Du Manuel D'utilisation Original page 54

Cleaning
After finishing work
• Using a dry brush, clean dust and chips
from ventilation slots.
• Using a lightly dampened cloth, clean
housing from outside and allow to dry
thoroughly.
Risk of damage to appliance!
Do not use liquids to clean the
electric planer! Do not use solvents!
In cases of frequent use
• wash collecting bag in warm, soapy
water and dry well to maintain air per­
meability.
Repair
Replacing drive belt
Risk of injury. Always unplug
from mains before replacing
drive belt!
Unscrew two bolts and remove cover.
54
MW-5410020-Bedien-2006.indd 54 MW-5410020-Bedien-2006.indd 54
Insert screwdriver between drive belt
and large drive wheel. Rotate the drive
wheel, while at the same time levering
off the drive belt.
Wrap new drive belt round the small
drive wheel so that the ridges on the
drive belt engage in the grooves in the
drive wheel.
Rotate the large drive wheel, while at the
same time slipping the drive belt onto it.
Replace cover and fasten with two bolts.
Replace carbon brushes
If carbon brushes are worn, the motor
will run unevenly, stop or start sluggishly.
The carbon brushes must be replaced
by approved specialists only.
Replacement carbon brushes are includ­
ed in the electric planer delivery.
Fault tracing and repair
• Electric planer will not start? Check
supply socket and associated mains
fuses. Ensure correct mains voltage
(see „Technical Data"). or: Have car­
bon brushes checked by approved
specialists.
• The planed surfaces are rough, une­
ven or slanted? The blades are dull,
20.05.20 12:23 20.05.20 12:23