Installation Instructions - Schumacher Electric DSR104 Guide D'utilisation

3. PREPARING TO USE THE BOOSTER
IMPORTANT: AFTER PURCHASE,
CHARGE YOUR BOOSTER FOR
24 HOURS, BEFORE USE.
WARNING! RISK OF CONTACT WITH
BATTERY ACID. BATTERY ACID IS A
HIGHLY CORROSIVE SULFURIC ACID.
3.1 Be sure the area around the battery is well
ventilated while the booster is being used.
3.2 Clean the battery terminals before using
the booster. During cleaning, keep
airborne corrosion from coming into
4. BOOSTER LOCATION
WARNING! RISK OF EXPLOSION
AND CONTACT WITH BATTERY ACID.
4.1 Locate the booster as far away from the
battery as the DC cables permit.

5. INSTALLATION INSTRUCTIONS

5.1 Remove all cord wraps and uncoil the cables
prior to using the charger and booster.
6. FEATURES
6
5
4
3
2
1
contact with your eyes, nose and mouth.
Use baking soda and water to neutralize
the battery acid and help eliminate
airborne corrosion. Do not touch your
eyes, nose or mouth.
3.3 Determine the voltage of the battery by
referring to the vehicle owner's manual
and make sure that the output voltage of
the booster is correct.
3.4 Make sure that the booster cable clips
make tight connections.
4.2 Never place the booster directly above
the battery being jumped; gases from the
battery will corrode and damage the booster.
4.3 Do not operate the booster in a closed-in
area or restrict the ventilation in any way.
5.2 After purchase, charge your booster for
24 hours, before use.
11
7
8
17
16
9
1. Output voltage selector
2. Output voltage connectors
3. Voltage selection LEDs
4. Charging port
5. 500A internal fuses
6. Alarm
7. Voltmeter
8. Voltmeter button
9. Battery clamps
10. Auxiliary cable port
(on back; not shown)
• 3 •
12
13
18
14
15
11. SC3DSR charger
12. Power LED
13. Start/Stop button
14. Clamps Reversed LED
15. Bad Battery LED
16. Charging LED
17. Charged/Maintaining LED
18. Charger plug