SSS Siedle BTSV 850-03 Notice D'utilisation page 4

English
Accepting door calls
The ringing tones for the front
door and apartment door are dif-
ferent. When a visitor presses the
door bell, the telephone rings and
the mute button flashes.
The call can be accepted by
pressing the speech button within
45 seconds after the last ringtone.
Actuating the door release
When you press the door release
button, the door from which the
last call came is opened for
3 seconds.
Switching on the light
When you press the light button,
the lighting is switched on, pro-
vided this has been connected by
your electrical installer.
Muting the bell
When the mute button is pressed
briefly, all the ringing tones are
switched off or on again. The
button lights up red to indicate
that the mute has been activated.
If a visitor rings the door bell while
the in-house telephone is switched
to mute, the button flashes.
Selecting a door station
Lift the receiver. Press the light
button twice to make a speech
connection to the door station
from which the last call came.
Ringtone volume
The ringtone volume can be set to
5 different levels:
With the receiver down, press
and hold down the muting button
for 3 seconds to hear the set ring-
tone volume.
4
Press the mute button briefly
and the volume increases by one
level. After the highest level it goes
back to the lowest level.
Save the selected volume
by pressing the mute button for
3 seconds.
Ringtone
You can choose between 11 ring-
tones. The ringtone is always set
for the last door to ring the door-
bell; consequently you will need to
first press the bell at the front door
or the apartment door. (A different
ringtone can also be selected for
internal or group calls).
With the receiver
down, press and hold down the
door release and light button
simultaneously for 3 seconds to
hear the set ringtone melody.
Pressing the muting button
changes the ringtone melody.
Save the selected ringtone
melody by pressing the mute
button for 3 seconds.
Switching on the monitor
Pressing the monitor button will
show the camera picture from the
door which placed the last door
call. This function is only possible if
there is currently no call connected.
Brightness and colour
Brightness and colour can be
adjusted using the two rotary
controllers.