Using The Kettle - SOLIS 558 Mode D'emploi

USING THE KETTLE

If you are using the kettle for the first time, or after a long interval, please fill it with water up to the
«MAX» mark and bring it to the boil. Pour the water away, refill the kettle with water and bring it to the
boil again, so that any particles of dirt that may be present inside the kettle are removed. Do not drink
this water.
1. Opening the lid
When you press the button integrated into the handle, the lid will open automatically.
2. Filling with water.
Take the kettle off the base station to fill. When you fill it with water, make sure that the level does not
fall below the «MIN» mark or rise above the «MAX» mark. Close the lid and place the kettle back on the
base station.
3. Temperature display
Once the water jug is placed on the base station and the plug is connected to the mains electricity supply,
the letter «C» will blink in the display. This means that the temperature will be indicated in degrees Celsius.
After a short time, the water temperature will appear on the display in degrees Celsius. If the appliance is
plugged in when the water jug is not on the base station, the letter «E» will appear in the display.
4. Modes of operation
ON/OFF button: if you operate the ON/OFF-switch in the normal Standby mode, the water will heat up
until it reaches 100° C. The kettle will then switch off automatically. An acoustic signal indicates the end
of the boiling process.
If you press the ON/OFF button while the kettle is heating up, the appliance will return to the Standby mode.
PROGRAM button: Press the PROGRAM button to change the temperature setting in any operating
mode. You can choose between the following temperatures:
40° C indicated by the illuminated spot in the top left hand corner of the display
60° C indicated by the illuminated spot in the top centre of the display
80° C indicated by the illuminated spot in the top right hand corner of the display
90° C indicated by the illuminated spot in the bottom right hand corner of the display
100° C indicated by the illuminated spot in the bottom centre of the display
Keep warm indicated by the illuminated spot in the bottom left hand corner of the display
The corresponding temperature will also be indicated in the display, depending on the selected programme.
After 3 seconds, the display will show the current temperature. After selecting the programme, press
the ON/OFF to start heating the water. The illuminated LED spot indicates the relevant programme and
you will be able to read the current water temperature off the display. The appliance will then switch off
completely when the water has reached the set temperature (except in the case of the "Keep warm"
programme).
After the kettle has switched off, the LED light on the display will flash on the selected programme. When
you press the ON/OFF button again, the LED point lights on the selected programme until you change it.
Solis_DigitalKettle-Betriebsanleitung.indd 29
29
16.02.11 18:01