Num'axes Canicom 250S Guide D'utilisation page 18

u Fitting the battery in the receiver collar
- Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the battery
housing (ref. Diagram 4).
CANICOM 250S_Indice A_CANICOM 200 18/01/2021 11:51 Page18
u Activate/deactivate the remote control
First use from new
- Activate: press for 1 second the On/Off red button
- Unscrew the 4 screws of the top of CANICOM using a screwdriver.
- Deactivate: press for 1 second the On/Off red button
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its housing.
Check the polarity before trying again
- Before putting the lid back in place, check that the rubber seal is in its groove.
- Screw up the 4 screws with care (do not overtighten them).
Polarity « - » of the battery
Remote control is supplied with battery fitted.
Diagram.1). Indications appear on the LCD screen.
LCD screen is off.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are not
using your CANICOM 250S for a long period.
Diagram 4
Gb - 18
Polarity « + » of the battery
located on the side of the remote control (ref.
( (
of the remote control (ref. Diagram.1). The
( (
Seal