Num'axes Canicom 250S Guide D'utilisation page 22

remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
CANICOM 250S_Indice A_CANICOM 200 18/01/2021 11:51 Page22
Checking/Replacing battery of receiver collar
To check the condition of the receiver collar battery, observe the On/Off indicator located on the front of
the receiver collar:
• Battery fully charged: flashes slowly green.
The performances of your CANICOM 250S will be optimal if you respect the following
• Weak battery: flashes quickly red. Replace it with a new battery (See § Fitting the battery in the receiver collar).
recommendations:
Check the receiver collar operates correctly.
Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
How to check that your CANICOM 250S is functioning properly
You can check that your CANICOM 250S is operating correctly at any time.
- Before doing so, make sure that the receiver collar is turned « off ».
- Place the neon test lamp in contact with each of the contact points (by unscrewing them then by
screwing them up in order to grip wires of the lamp under the contact points).
- Turn « on » the remote control and receiver collar.
- Press the « F » or « C » button and modify the level of intensity of the stimulations: the test lamp will
come on with more or less intensity.
Getting the best results
The training instructions you send to your dog are sent from the remote control to the receiver collar by
radio waves. These radio waves are sensitive and the range reaches approximately 250 meters
(depending on geography and environment).
Gb - 22