First Use From New - Num'axes CANICOM 1000 Guide D'utilisation

First use from new

 ◆ Fitting the battery in the receiver collar
- Unscrew the 4 screws of the top of CANICOM using a screwdriver.
- Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the battery
housing (ref. Diagram 4).
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its housing.
Check the polarity before trying again
- Before putting the lid back in place, check that the rubber seal is in its groove.
- Screw up the 4 screws with care (do not overtighten them).
Polarity « - » of the battery
Diagram 4
 ◆ Activate/deactivate the remote control
Remote control is supplied with batteries fitted.
- Activate: press for 1 second the On/Off red button (
Diagram.1). Indications appear on the LCD screen.
- Deactivate: press for 1 second the On/Off red button (
LCD screen is off.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are not
using your CANICOM 1000 for a long period.
 ◆ Activate/deactivate the receiver collar
A magnet located in the remote control is used to either switch on/off the receiver collar.
- Activate: approach the area where the On/Off switch magnet is located inside the remote control until
coming in contact on white indicator located on the receiver collar, hold for 1 second (ref. Diagram 5),
the indicator light on the collar will flash in green indicating that the collar is On.
Gb - 18
Polarity « + » of the battery
( (
) located on the side of the remote control (ref.
( ( ) of the remote control (ref. Diagram.1). The
Seal