Num'axes Canicom 250S Guide D'utilisation page 19

u Activate/deactivate the receiver collar
- Activate: approach the red area where the magnet is located inside the remote control until coming in
contact on red indicator located on the receiver collar, hold for 1 second (ref. Diagram 5), the indicator
light will flash in green indicating that CANICOM is on .
CANICOM 250S_Indice A_CANICOM 200 18/01/2021 11:51 Page19
- Deactivate: approach the red area where the magnet is located inside the remote control until coming
in contact on red indicator located on the receiver collar, hold for 1 second (ref. Diagram 5), the indicator
light will flash from green to red and then off: the collar is off .
To increase the battery life of the receiver collar, we recommend you deactivate the unit if you are no
longer using your CANICOM 250S for a long period.
A magnet located in the remote control is used to either switch on/off the receiver collar.
u Coding of the remote control and receiver collar
IMPORTANT: before beginning the coding, make sure no other person is using his CANICOM 250S
or other products from the NUM'AXES range close by: your receiver collar could accidentally
record the code of his remote control. If that occurs, re-code the remote control with the receiver
collar.
REMOTE CONTROL
Each remote control has its individual radio operator code. The coding of the remote control with the
receiver collar enables the two units to work together.
Diagram 5
during 1 second
Gb - 19
Approach until coming in contact those 2 areas
COLLAR