Maico AE 10/1 Instructions De Montage Et Mode D'emploi page 48

AE 10/1, AE 15/1
5. Electrically connect the power cable
to the spring clip
chapter
6. Fit electronics cover [3].
10 Commissioning
1. Switch on mains fuse, remove warning
sign.
2. Check that the technical data has been
adhered to
3. Run function test.
11 Setting the shutter/closing angle
Determine the closing angle of the lamellae
with the enclosed setting screw [7].
Basic ventilation in switching status "Off"
with lamellae that are always slightly open.
Fasten the screw in the thread at the lower
edge of the housing. Set the minimum
DE

18.
Rating plate.

UK
Wiring diagram in
VENTILATOREN
FR