™
3M
Digital Media System 700 Series
Warranty; Limited Remedy; Limited Liability
This product will be free from defects in material and manufacture for a period of one year from the date
of purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective
within the warranty period stated above, your exclusive remedy shall be, at 3M's option, to replace or repair the
3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be
liable for any indirect, special, incidental or consequential loss or damage arising from this 3M product,
regardless of the legal theory asserted. To obtain warranty service outside of the USA, immediately notify the
dealer from which you purchased the product of any defects. In the USA call 1-800-328-1371 for warranty or
repair service.
The warranty for lamps that are included as original equipment in the projectors is for parts only and is effective for
a period of 90 days after the date of purchase of the projector or 180 hours of lamp usage,whichever occurs first.
Important: The above warranty shall be void if the customer fails to operate product in accordance with 3M's
written instructions. This warranty gives you specific legal rights and you may have other rights that vary from
state to state.
REGULATORY NOTICES
FCC STATEMENT - CLASS A: This equipment generates, uses and can radiate radio frequency
energy, and if not installed and used in accordance with the instruction manual may cause interference to
radio communications. It has been tested and found to comply with the limits for a Class "A" computing
device pursuant to Subpart B of Part 15 of the FCC Rules, which are designed to provide reasonable
protection against such interference when operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference in which case the user at his/her own
expense will be required to take whatever measures may be required to correct the interference.
EEC STATEMENT
• This machine was tested against the 89/336/EEC (European Economic Community) for EMC (Electro
Magnetic Compatibility) and fulfills these requirements.
• This machine was tested against the 73/23/EEC (European Economic Community) for LVD (Low
Voltage Directive) and fulfills these requirements.
This product is compliant with EU Directive 2002/95/EC (Restriction of Hazardous Substances in Electrical and
Electronic Equipment), as amended by Commission Decision 2005/618/EC on maximum concentration values.
This product is compliant with EU Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
© 3M 2007. All Rights Reserved.
Introduction
9