Setting The Modem Password; Setting The Logical Address Of The Main (Master) Monitors; Setting The Logical Address Of Secondary (Slave) Monitors - Comelit iPower 8595 Mode D'emploi

20

Setting the modem password

1. Enter the Installer menu (See point 19).
2. Select the Program Monitor menu using the
press the button to enter.
INSTALLER MENU
Program monitor
3. Select the Set bracket menu using the
the button to enter.
PROGRAM MONITOR
Logical address
Set bracket
Information
Reset configuration
Select network type
4. Press the button to enter the Change Password menu.
BRACKET SETTINGS
MAC: 00:0D:BE:00:2C:65
PWD: 0007
ID: A
Change Password
• The and buttons increase and decrease the selected value
• The and buttons move the selection cursor left and right.
5. Change the password.
PASSWORD SETTING
Modem password: 1 0 0 7
Left Right
6. Press the button to save the new password.
21
Set 1 single main monitor for each logical address.
1. Enter the Installer menu (See point 19).
, buttons and
2. Select the Program Monitor menu using the
press the
, buttons and press
3. Press the
4. Change the address using the
5. Press the
22
Each secondary monitor in the same residential unit must have a
different Slave Address
1. Enter the Installer menu (See point 19).
2. Select the Program Monitor menu using the
press the
Setting the logical address of the
main (master) monitors
button to enter.
INSTALLER MENU
Program monitor
button to enter the Logical address menu.
PROGRAM MONITOR
Logical address
Set bracket
Information
Reset configuration
Select network type
, buttons.
ADDRESS SETTING
Logical address 0 2
Master
Slave 1 4
Left Right
button to exit and save the changes.
Setting the logical address of
secondary (slave) monitors
button to enter.
INSTALLER MENU
Program monitor
, buttons and
EN
, buttons and
37