Operating Instructions - Skil AG290201 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-contain ng products, etc, can cause a short
circuit.
WARNING
could result in serious personal injury.
WARNING
is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
assembling parts.
This cordless angle grinder must be used only with the battery packs and charger listed below:
2Ah
SKIL BY519701
NOTICE: Please refer to the battery and charger manuals for detailed operating information.
Wheel Guard Installation (Fig. 2, 3)
WARNING
direct the guard opening toward your body.
Turn the tool OFF and remove the battery pack before performing any assembly.
To install the wheel guard:
a. Open the guard latch and position the wheel guard on the spindle neck so that the two
bumps on the guard line up with the two notches on the spindle neck.
b. Rotate the wheel guard to the desired position, then close the latch to secure the guard in
place.
Fig. 2
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery ack or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced. Use of this product with damaged or missing parts
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration or modification
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when
Battery Pack
4Ah
SKIL BY519601
Use wheel guard with disc grinding wheels. Always close the latch to
secure the guard. Keep the guard between you and the wheel. Do not
5Ah
SKIL BY519603
Charger
SKIL SC535801
13