Grinding Wheel Assembly - Skil AG290201 Guide D'utilisation

c. Check to ensure that the wheel guard is
securely clamped to the spindle neck. If the
guard latch does not securely clamp the
wheel guard to the spindle neck, place the
wheel guard on the spindle neck, close the
latch, then tighten the adjustment screw to
increase the clamping tension (Fig. 3). Check
it again and do not proceed until the wheel
guard is properly clamped in place.
To remove the wheel guard:
a. Open the guard latch; rotate the wheel guard
until the bumps on the guard line up with the
notches on the spindle neck.
b. Lift the wheel guard off the spindle neck.

Grinding Wheel Assembly

Turn the tool OFF and remove the battery pack before performing any assembly. Be sure that
the wheel guard is in place for grinding.
To install the grinding wheel:
a. Place the backing flange on the spindle. Check to ensure that the backing flange is properly
seated on the spindle. It will click into place on the spindle and will cause the spindle to
rotate when the backing flange is rotated.
b. Place the grinding wheel on the backing flange.
c. Thread the lock nut on the spindle with the flat side of the flange facing outside. Make sure
that the opening in the grinding wheel is positioned around the raised portion of the lock nut
(Fig. 4).
Fig. 4
Lock Nut
Grinding Wheel
Backing Flange
Spindle
14
Fig. 3
Lock Nut
Backing Flange
Spindle
Grinding Wheel