Publicité
Les langues disponibles
Les langues disponibles
3) Hold the RECORD/SHIFT button down and press quickly TWICE the appropriate flash
button from section PRESET B in which the pattern to be erased is stored.
4) Release the RECORD/SHIFT. All indicator LEDs light up to confirm.
CHANGING A RUNNING LIGHT PATTERN
A running light pattern (scene) can contain up to 99 steps. These steps can be changed or
erased later. You can also add steps later. Each 'step' is a determined setting of the variable
light intensity (0-100%) of 24 lamps or groups of lamps.
Erasing a particular step:
1) Activate the programming mode (press RECORD/SHIFT and simultaneously 1, 5, 6, and 8).
2) Select the required page via the PAGE button.
3) Press the MODE SELECT button until the red LED lights up (CHASE-SCENES).
4) Hold the EDIT button down and press at the same time the flash button of the appropriate
running light pattern (flash buttons in the lower row of the section PRESET B).
5) Release the EDIT button and select via the STEP button the step to be erased.
6) Press the DELETE button and the selected step will be erased from the memory.
7) Leave the programming mode by holding the RECORD/SHIFT button down while pressing
twice the REC/EXIT button.
Adding steps:
1)
Activate the programming mode (press RECORD/SHIFT and simultaneously in sequence 1,
5, 6, and 8).
2)
Select the required page via the PAGE button.
3)
Press the MODE SELECT button until the red LED lights up (CHASE-SCENES).
4)
Hold the EDIT button down and press at the same time the flash button of the appropriate
running light pattern (flash buttons in the lower row of the section PRESET B).
5)
Release the EDIT button and select via the STEP button the step just after the step to be
added.
6)
Set the required light position via the slider controls, press the RECORD/SHIFT button and
then the INSERT button.
7)
If required, repeat steps 5 and 6 to add more steps.
8)
Hold the RECORD/SHIFT button down and press twice the REC/EXIT button to leave the
programming mode.
Changing steps:
1)
Activate the programming mode (press RECORD/SHIFT and simultaneously in sequence 1,
5, 6, and 8).
2)
Select the required page via the PAGE button.
3)
Press the MODE SELECT button until the red LED lights up (CHASE-SCENES).
4)
Hold the EDIT button down and press at the same time the flash button of the appropriate
running light pattern (flash buttons in the lower row of the section PRESET B).
5)
Select the required step via the STEP button.
6)
Now you can change the light intensity of the lamps as follows: hold the DOWN button
pressed while pressing the flash button of the channel that you want to change. The
display shows which setting has been selected. (0 – 255 is equivalent to 0 – 100%)
7)
Hold the RECORD/SHIFT button down and press twice the REC/EXIT button to leave the
programming mode.
MUSIC CONTROL
Connect an audio source to the RCA input at the rear side (100mV p-p). Switch the music
control on via the AUDIO button. The green LED lights up. Set the required effect via the slider
control AUDIO LEVEL.
STORING A RUNNING LIGHT SPEED
1) Switch the music control off.
Publicité
