Skytec 154.062 Mode D'emploi page 2

General Description
This digital DMX 'scene setter ' light controller can control 24 light channels and gives total
dimmer control over all 24 outputs. It features 48 easily programmable memories with a
storage capacity for 99 different light effect scenes per memory. It can be set on automatic
control or on music control via the built-in microphone or via an external audio signal. The
speed and fade time for the running light are also selectable. The digital DMX-512 control uses
"addresses" for the individual control of the connected light units. These outgoing addresses
are pre-set to the numbers 1 to 24.
Controls and Functions
1) Indicator LEDs for the setting of the slider controls from section A.
2) 12 slider controls adjusting the light intensity of channel 1 to 12.
3) Push-buttons with 'flash' function for channel 1 to 12.
4) Indicator LEDs for the setting of the slider controls from section B.
5) LED indicating the active scenes.
6) Slider controls for the channels 13 to 24.
7) Flash buttons 13 to 24 allowing to completely switch on shortly one channel.
8) MASTER A slider control for the setting of the light intensity on channel 1 to 12 (section A)
or on all 24 channels simultaneously.
9) 'BLIND' button to exclude one or more channels simultaneously from a scene pattern. The
light intensity of that channel will then be determined by the appropriate slider control of
the channel.
10) MASTER B slider control setting the light intensity of channels 13 to 24.
11) 'HOME' button to switch off the 'Blind' function.
12) Slider control for the setting of the fade time between the scenes.
13) TAP SYNC button to synchronize the STEP rhythm with the music.
14) SPEED slider control to set the STEP speed of the running light patterns.
15) 'FULL-ON' button to switch all outputs to 100% intensity.
ENG