Vent Cover Bracket Installation - Haier HCH2100ACS Guide De L'utilisateur

Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
4. Using 2 or more people, lift range hood onto covered surface.
MOUNT RANGE HOOD TO THE WALL
1. Determine and mark the centerline on the wall where the canopy hood will be
installed.
2. Select a mounting height between a minimum of 24" (61.0 cm) for an electric
cooking surface, a minimum of 27" (68.6 cm) for a gas cooking surface, and a
suggested maximum of 36" (91.4 cm) above the range to the bottom of the
hood. Mark a reference line on the wall.
3. Place the vent hood on the wall, adjust to align and fasten with screws and screw
anchors suited to the wall type (reinforced concrete, plasterboard etc.)
4. Mark centers of the fastener locations through the template to the wall.
IMPORTANT: All screws must be installed into wood. If there is no wood to screw
into, additional wall framing supports may be required.
Remove the template.
5. Drill ³⁄₁₆" (4.8 mm) pilot holes at all locations where screws are being installed into
wood.
6. Install the 2 - 5 x 45 mm mounting screws. Leave a ¹⁄₄" (6.4 mm) gap between the
wall and the back of the screw head to slide range hood into place.

VENT COVER BRACKET INSTALLATION

1. Attach vent cover bracket to wall flush to the ceiling using 2 - 5 x 45 mm screws.
8
WARNING
Excessive Weight Hazard
1/4"
(6.4 mm)
b
c
a