Complete Preparation; Install Range Hood - Haier HCH2100ACS Guide De L'utilisateur

COMPLETE PREPARATION

1. Determine and make all necessary cuts in the wall for the vent system. Install the
vent system before installing the hood. See "Venting Requirements" section.
2. Determine the required height for the home power supply cable and drill a 1¼"
(3.2 cm) hole at this location.
3. Run the home power supply cable according to the National Electrical Code
or CSA Standards and local codes and ordinances. There must be enough ½"
conduit and wires from the fused disconnect (or circuit breaker) box to make the
connection in the hood's electrical terminal box.
NOTE: Do not reconnect power until installation is complete.
4. Use caulk to seal all openings.

INSTALL RANGE HOOD

1. Using 2 or more people, hang range hood on 2 mounting screws through the
mounting slots on back of hood.
2. Remove the grease filter. See "Range Hood Care" section.
3. Level the range hood and tighten upper mounting screws.
4. Install 2 - 5 x 45 mm lower mounting screws and tighten.
9