Step 4 - Complete Preparation; Step 5 - Install Range Hood - Haier HCH2100ACS Guide De L'utilisateur

2. Attach support bracket to wall flush to the ceiling using two - 5 x 45 mm screws.

STEP 4 - COMPLETE PREPARATION

1. Determine the required height for the home power supply cable and drill a 1¼"
(3.2 cm) hole at this location.
2. Run the home power supply cable according to the National Electrical Code
or CSA Standards and local codes and ordinances. There must be enough ½"
conduit and wires from the fused disconnect (or circuit breaker) box to make the
connection in the hood's electrical terminal box.
NOTE: Do not reconnect power until installation is complete.
3. Use caulk to seal all openings.

STEP 5 - INSTALL RANGE HOOD

IMPORTANT:
•
If the range hood is being installed above an installed range, ensure the range is
turned off and has cooled completely before beginning installation.
•
Do not remove the plastic film from the range hood until installation is complete.
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
10
a
b
c
WARNING
Excessive Weight Hazard
a
Ceiling
b
Wall
c
Centerline