Reely ROAD XL Maximus II 4WD RtR Notice D'emploi page 51

Chassis
Model pulls to one side
Model can be controlled only with
difficulty
Brake is ineffective
Clutch does not engage
Clutch does not disengage
Model does not run
Dampening not soft and smooth
Shock absorbers lose oil
Model flips backward when
accelerating
Steering trim is misadjusted
Alignment is different on the right and left
Wheel broken on one side or bearing defective
Servo linkage not set correctly
Too low receiver power of the aerial
Transmitter and/or receiver batteries are discharged
Brake linkage misadjusted.
Brake discs worn out
Clutch clamps are worn or defective
Clutch bells are worn or defective
Flywheel is loose
Springs for clutch clamps are worn or defective
Main cogwheel defective.
Defective cogwheels in the differentials
Centrifugal clutch set too loosely
One or several shock absorbers are caught
Piston rod bent
A component of the dampening is defective
Seals worn
Centrifugal clutch set too tightly
Correct the neutral position at the remote control
Set the alignment back to 0° on both sides
Remove the wheel, clean the bearing and replace it if required
Put servos to the neutral position and re-adjust
Fully extend transmitter aerial, completely uncoil the receiver aerial
and guide it upwards
Replace batteries or charge rechargeable batteries
Correct the brake linkage lever settings
Replace the brake discs
Replace the clutch clamps.
Replace the clutch bell
Re-tighten the flywheel attachment
Replace the springs.
Replace the main cogwheel
Replace the cogwheels
Readjust the centrifugal clutch.
Clean and/or disassemble the shock absorber
Repair the piston rod
Check and replace the corresponding part
Replace the seals
Loosen the adjustment screw until the model starts up softly
51