3.5
Safety instructions
Electrical current
DANGER
Electric shock!
The pump is operated electrically. An electric shock
may be a danger to life!
ƒ
Have only qualified electricians carry out work on electrical com-
ponents.
ƒ
Before all work, deactivate the power supply (if necessary, SSM
and SBM) and safeguard against accidental switch-on. Work on
the control module may only be started after 5 minutes have
elapsed, due to the dangerous residual contact voltage.
ƒ
Operate pumps exclusively with intact components and connec-
tion cables.
Magnetic field
DANGER
Magnetic field!
The permanent magnet rotor inside the pump can
pose mortal danger for people with medical implants
(e.g. pacemakers) during dismantling.
ƒ
Never open the motor and never remove the rotor.
Installation and operating instructions Wilo-Stratos MAXO/-D/-Z
Hot components
WARNING
Hot components!
Pump housing, motor housing and lower module
housing can get hot and cause burns if touched.
ƒ
When in operation, only touch the user interface.
ƒ
Allow the pump to cool down before commencing any work.
ƒ
Keep highly flammable materials away.
4
Transportation and storage
4.1
Scope of delivery
➜ Fig. 1 and 2
4.2
Accessories
Accessories have to be ordered separately.
ƒ
CIF modules
ƒ
PT1000 (Contact and immersion sensor)
ƒ
Counter flanges (DN 32 to DN 100)
ƒ
ClimaForm
See catalogue for detailed list.
4.3
Transport inspection
Check delivery immediately for damage and completeness. Where
necessary make a complaint immediately.
en
35