HSM 450.2 Notice D'utilisation page 11

HSM 450.2
6. Start-up
Switching paper shredder on
• Pull out emergency-stop.
I
• Turn main switch to position I.
I
0
• Paper shredder is ready for ope-
ration when green LED on control
panel lights.
Notice
Safety switches are installed at
the doors. Paper shredder is only
to switch on if there are all doors
closed.
• Press the green arrow button.
Press briefl y: cutting device
starts
Automatic stop approx. 3 se-
conds after the last piece of pa-
per was drawn in, or manual stop
when the stop button is pressed.
Hold down for longer than 2
seconds:
constant operation without light
barrier function
The cutting device runs until it is
switched off with the stop button.
Insert paper into the paper feed
apertures
Paper feed slot:
smooth paper + stacks of continuous lists
0602
Paper shredder
The tray can be
folded out to hold
stacks of paper or
continuous lists.
The shredder bla-
des are controlled
by the light barrier
in the paper feed
slot.
english
Filling drum:
crumpled paper
Switching paper shredder to stand-
by mode
• Press stop pushbutton.
Cutting system stops.
Paper shredder continues to
be ready for operation (standby
function).
Switching paper shredder off
I
• Turn main switch to position 0
(secure main switch with a pad-
0
0
lock, if necessary).
7. Scope of delivery
• Single machine, ready for connection, foil
packaging
• Machine on pallet with wooden crate
• 5 cut material bags
• Special cutting block oil (250 ml)
• Operating instructions
Acces so ries
• Cut material bag, Part-No. 1.452.995.000
• Special cutting block oil (250 ml), Part-No.
1.235.997.401
Pull the drum hand-
le forward and put
the crumpled paper
in the drum.
When you push
back the handle the
paper falls into the
shredder blades.
11