Others; Wall Mounting; Pillow Shaker - Doro Secure 350 Guide Utilisateur

IMPORTANT!
The only way to stop the alarm sequence is if the called party
•
accepts the call within 60 seconds by pressing 0 (zero), or
when all the alarm numbers have been dialled.
The receiver of the alarm call, the alarm contact, can disconnect
•
the call immediately by pressing 1 2 after having accepted
the call with 0 .
Automatic calls to police, fire brigade etc. are not normally
•
allowed. Therefore, you should not program these numbers as
alarm contacts. Some private security companies can accept
automatic calls from their clients. Always contact the security
company before programming in its number.
Check regularly that the alarm call function is properly set up
•
and functional.

Wall mounting

The phone can be wall mounted using the included wall mount bracket and two
screws (not included).
WARNING
Make sure that no cables, water pipes or gas pipes are located inside
the wall before drilling into it.
1. Drill two holes in the wall, vertically 83 mm apart.
2. Insert the screws, allowing them to project ~5 mm out from the wall.
3. Unplug and remove the handset.
4. Fit the guide tabs on the bracket into the slots on the back of the phone, then
slide the bracket upwards until it snaps into place.
5. Position the phone so that the screws on the wall fit into the slots in the
bracket, then slide the phone downwards until it is hanging on the screws.
6. Reconnect the handset and place it in the cradle.

Pillow shaker

A pillow shaker such as Doro HearPlus 55v can be connected to the socket
English

Others

15
.