Installation; Connection; Batteries - Doro Secure 350 Guide Utilisateur

This device is intended for the analogue telephone network lines in
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU, IE, IS,
IT, LV, LT, LU, MT, NL, NO, PL, PT, RO, SI, SK, SE.

Connection

1. Connect the curly cord to the handset and then to the socket
marked q on the unit.
2. Connect the mains adapter (if included) to an electrical wall
socket and then to the socket marked DC 9V/300mA on the unit.
3. Connect the telephone line cord to a network wall socket and
then to the socket marked K on the unit.
4. Lift the handset and listen for the dial tone.
5. Position the cables in the grooves underneath the unit.
Note!
Use supplied telephone line cord, an existing cord from a previous
phone may not be compatible.

Batteries

The unit is powered with the provided mains adapter and has batteries
as backup in the event of a power cut. 4 AA alkaline batteries are
needed for full functionality in the event of a power cut. Typical
backup time, 15 hours with new batteries. When
replace all 4 batteries. Use only AA alkaline batteries of good quality
(not included).
Note!
Before installing or changing the batteries, make sure that the phone is
not connected to the telephone network.
1. Remove the battery cover and insert the batteries ensuring correct
battery polarity is observed.
2. Replace the battery cover and reconnect the telephone line cord.
English

Installation

1
is displayed,