Doro Secure 350 Guide Utilisateur page 35

Storing contacts
1. Press W, use v/V to scroll to STORE NO.. Press 0.
2. Enter a phone number. Use v/V to move the cursor and
to erase if needed. Use # to insert a pause in the number.
3. Press 0 to confirm. A blinking cursor is displayed on the second
line on the display.
4. Enter a name for the contact (see
5. Press 0 to confirm.
Select ALARM ON or ALARM OFF. Press 0 to confirm.
6.
IMPORTANT!
Select ALARM ON if the contact should be stored as an "alarm
contact". See
7. If ALARM ON is selected, AL.POS? is displayed. Select the
required location (1-30) by pressing v/V. Press 0 to confirm.
Note!
AL.POS? sets the dialling order of an alarm call.
8. SAVED is displayed and then NAME REC. You can now record a
name to be read aloud with the entry.
To record, press and hold 0 until a tone is heard, say the name,
then release the button (or else the unit stops after 4 seconds).
Speak clearly and about 15–20 cm from the phone.
If you select ALARM OFF, press 0, SAVED is displayed and
then NAME REC.
9. Repeat steps 2–9 to store another contact, or press and hold
to exit.
Note!
Selecting location (AL.POS?) is very important because this determines
the chronological order of the phone numbers that will be dialled in
case of emergency. Location 1 will be dialled first, then 2, then 3 etc.
If you choose to overwrite a location, the previously stored number will
be set to one location "after" the location you just set.
Editing contacts
1. Press b.
2. Use v/V to select desired contact.
English
Alarm function,
10
Keypad characters, p. 8
p.13.
).