Cordless Pendant; Changing Batteries In The Cordless Pendant - Doro Secure 350 Guide Utilisateur

The standard setting is 100 for most countries, 300 for
France/Portugal, 600 for New Zealand.
N CALL LED
Enable/disable the LED indicator for new calls.
Select ON/OFF and confirm with 0. See
TONE/PULSE
Select either TONE or PULSE dialling mode, and confirm with 0.
Note!
If unsure of which mode to use, select TONE as this works in most
locations.
SERVICES
Buttons 1 and 2 can be programmed with service number.
Scroll to SERVICES. Press 0.
1.
2. Select 1 or 2 . Press 0.
3. Enter the required number and confirm with 0.
To dial, press and hold 1 or 2 and press
The range of the cordless pendant varies depending on the
environment in which it is used. Walls, floors, furniture and other
obstacles may limit contact between the pendant and the phone.
Check that the pendant is always in contact with the phone by
activating the alarm in different places around the premises.
See PENDANT, p. 2

Changing batteries in the cordless pendant

If the cordless pendant ceases to function, change the batteries. Use
only 12 V (A23, LR23) Alkaline battery of good quality.
1. Use a Phillips screwdriver to loosen the screws on the back and
separate the parts gently.
2. Replace the battery, take care to follow the markings for plus
and minus terminals.
English

Cordless pendant

on how to register (pair) a pendant.
5
Caller ID and call log, p.12
or lift the handset.