Wilo PARA/SCA Série Notice De Montage Et De Mise En Service page 43

Select control mode
LED display
1
2
3
4
5
6
Installation and operating instructions Wilo-Para SCA
7.2 Setting the control mode
The LED selection of control modes and corresponding
pump curves takes place in clockwise succession.
• Press the operating button briefly (approx. 1 second)
for setting change.

LEDs display the set control mode and pump curve.
The following shows the various possible settings (for
example: Speed control range: high, setting/curve II):
Control mode
Speed control range: high
Speed control range: low
Speed control range: low
Speed control range: low
Speed control range: medium
Speed control range: medium
Setting/curve
I
III
II
I
III
II
43