Battery Connections For Electric Starter; Remote Control Linkage - Honda GCV520 Manuel De L'utilisateur

Battery Connections for Electric Starter

Recommended Battery
GCV520 12 V–30 Ah
GXV520
GCV530 12 V–30 Ah
GXV530
Be careful not to connect the battery in reverse polarity, as this will
short circuit the battery charging system. Always connect the
positive (+) battery cable to the battery terminal before connecting
the negative (–) battery cable, so your tools cannot cause a short
circuit if they touch a grounded part while tightening the positive
(+) battery cable end.
A battery can explode if you do not follow the correct
procedure, seriously injuring anyone nearby.
Keep all sparks, open flames, and smoking materials
away from the battery.
WARNING: Battery posts, terminals, and related accessories
contain lead and lead compounds. Wash hands after handling.
1. Connect the battery positive (+) cable to the starter solenoid
terminal as shown.
2. Connect the battery negative (–) cable to an engine mounting
bolt, frame bolt, or other good engine ground connection.
3. Connect the battery positive (+) cable to the battery positive
(+) terminal as shown.
4. Connect the battery negative (–) cable to the battery negative
(–) terminal as shown.
5. Coat the terminals and cable ends with grease.
BATTERY
POSITIVE (+) CABLE
BATTERY
NEGATIVE (–) CABLE
14

Remote Control Linkage

The throttle and choke control levers are provided with holes for
optional cable attachment.
The following illustrations show installation examples for a solid
wire cable. Do not use a braided wire cable.
Single Lever Type:
CHOKE RETURN SPRING
INSTALLATION:
Install with the short
end hook toward the
control base side.
CONTROL LEVER
Dual Lever Type:
CHOKE RETURN SPRING
INSTALLATION:
Install with the short
end hook toward the
control base side.
STARTER
SOLENOID
CHOKE LEVER
ENGLISH
THROTTLE/CHOKE
CABLE (SOLID WIRE)
5×16 mm SCREW
CABLE HOLDER
STOPPER RUBBER
INSTALLATION:
To install the stopper
rubber, first align the boss
with the hole of the
control lever bracket, then
turn the rubber 90° and
secure it to the bracket as
shown.
LEVER SPRING
THROTTLE CABLE
(SOLID WIRE)
5×16 mm SCREW (2)
CABLE HOLDER (2)
CHOKE CABLE
(SOLID WIRE)
THROTTLE LEVER