Tool Specifications; Operating Controls - Festool HK 132 E Notice D'utilisation D'origine

Hand Circular Saw HK 132 E
Original instruction
Table of contents
1 Symbols ...........................................................16
2 Tool Specifications ...........................................16
3 Operating Controls ..........................................16
4 Intended Use ...................................................17
5 Notes on Safety Prevention .............................17
6 Commissioning and Operation .......................19
7 Adjustment ......................................................19
8 Operating Instructions ....................................20
9 Using Attachments ..........................................21
10 Maintenance ...................................................22
11 Environment ....................................................22
12 EU Declaration of Conformity ..........................22
1 Symbols
Double insulation
Warning of general danger
Risk of electric shock
Read the operating instructions/notes!
Wear a dust mask!
Wear ear protection!
Wear protective gloves!
Do not throw in the household waste!

Advice or tip
2 Tool Specifi cations
Nominal voltage
Mains frequency
Power consumption
Rated rmp (no load)
Constant-Electronic
Smooth start
Overload protection
Temperature fuse
Saw blade ø
GB
220 -240 V ~
50 / 60 Hz
2300 W
-1
2200 min
•
•
•
•
350 mm
Hole
Tooth width
Blade thickness
Cutting depth 60°
45°
Cutting angle
Weight (without accessories)
Protection class
3

Operating Controls

[1-1] Sawdust ejector
[1-2] Lever for pendulum guard
[1-3] Additional handhold
[1-4] Additional handhold for 2-man operation
[1-5] Parallel guide for guide rail
[1-6] Locking screw for parallel guide
[1-7] Cutting angle locking lever
[1-8] Cutting edge indicator
[1-9] Pendulum guard
[1-10] Clamping screw
[1-11] Riving knife
[1-12] Riving knife screw
[1-13] On/Off switch
[1-14] Lock-off switch
[1-15] Cutting depth scale
[1-16] Cutting depth locking lever
[1-17] Additional handhold for 2-man operation
[1-18] Cutting angle locking lever
[1-19] Cutting angle scale
[2-1] Winged screw for parallel guide
[2-2] Base plate
[2-3] Parallel guide (right hand fi tting)
[2-4] Parallel guide for guide rail
[3-1] Clamping screw
[3-2] Clamping fl ange
[3-3] Saw blade
[3-4] Mounting fl ange
[3-5] Lever for swinging guard
[4-1] Additional handhold
[4-2] Additional handhold
[5-1] Blade guard cover plate
[5-2] Pendulum guard cover plate
[5-3] Dust extraction connection
[5-4] Riving knife
[6-1] Mounting fl ange
[6-2] Clamping fl ange
[6-3] Planing head
[6-4] Retaining pin
16
30 mm
3.5 mm
2.5 mm
0 ... 60 mm
0 ... 90 mm
0° ... 60°
16 kg
II /