Data Plate Details; Information Regarding The Recycling And Reuse Of The Materials; Special Requirements For Critical Components; General Description - Seko K500 TB Manuel D'installation

In order to determine the locations of the ATTENTION symbols on the device, refer to chapter 2
"Controls and Indicators, Connections" and chapter 3 "Installation" of this user manual. These
chapters provide illustrations of the device's panels, with their relative controls, connections,
symbols and labels. Each attention symbol is accompanied by a detailed explanation of its meaning.
1.5

DATA PLATE DETAILS

1.6 INFORMATION REGARDING THE RECYCLING AND REUSE OF THE
MATERIALS
In compliance with the specific European directives, and in order to minimize the negative
environmental impact of the device's components, consumables and packaging, as well as the
device itself at the end of its working life, the manufacturer is constantly working to improve the
design and production procedures for its products.
The packaging is designed and manufactured to allow for the majority of the materials to be
recovered, reused and/or recycled, as well as to minimize the amounts of waste and/or residues to
be disposed of. In order to ensure minimal environmental impact, the device has been designed
using the maximum possible circuit miniaturisation, with the smallest possible amount of material
and component differentiation, with select materials that guarantee maximum recyclability, with
maximum parts re-use and with disposal procedures free of environmental risks.
The device is manufactured in such a way so as to guarantee that any materials containing pollutant
substances can be easily separated or disassembled from the others, particularly during maintenance
and part replacement operations.
The disposal/recycling of the packaging materials, the consumables and the device itself at
the end of its working life must be carried out in compliance with the current regulations
and directives of the country in which the device is utilised.
1.6.1

SPECIAL REQUIREMENTS FOR CRITICAL COMPONENTS

The device is equipped with a liquid crystal display (LCD), which contains small amounts of toxic
materials.
2

GENERAL DESCRIPTION

The analyser described in this manual is comprised of an Electronic Control Unit and a Technical
Manual
The control unit may be installed upon the electrical panel or else wall-mounted at a maximum
distance of 15 metres from the probe.
0000137221
Mod.
SN.
XXXXXXX
Volt Hz
100-240 Vac/dc
SW Ver.
X.X
ATTENTION
Rev. 3.1
50/60
8