Installation; Composition Of The Consignment; Installation Of The Wall-Mounted Control Unit - Seko K500 TB Manuel D'installation

3

INSTALLATION

Carefully read the information below before installation.
3.1

COMPOSITION OF THE CONSIGNMENT

3.1.1

INSTALLATION OF THE WALL-MOUNTED CONTROL UNIT

The wall must be completely smooth in order to allow for the perfect adhesion of the control unit.
Figure 5 – Dimensions and encumbrance of the wall-mounted control unit
Dimensions (L x H x D)
Installation depth
Material
Installation typology
Weight
Front Panel
Open the device, drill the indicated holes and fasten the device to the wall. Cover the holes
internally using the relative caps, which come supplied along with the device.
The cable glands for the electrical connections are located on the lower portion of the control unit.
In order to facilitate the connections, therefore, any other devices must be positioned at least 15 cm
away.
Protect the device against any drips and/or sprays of water from adjacent areas during the
programming and calibration phases.
0000137221
Mechanical Dimensions
144x144x122.5mm
122.5mm
ABS Grey RAL 7045
Wall-mounted
UV resistant polycarbonate
Rev. 3.1
1 Kg
18