Télécharger Imprimer la page

Costan MIURA Instructions Pour L'utilisateur page 23

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
CONTROLS
Down on the right, cabinets are fitted with a switch for the control of product lighting and with a remote thermo-
stat/thermometer for temperature control. The remote thermostat displays the temperature existing inside the case and
allows temperature control by the use of the appropriate keys.
WARNING: Adjustment is reserved for the technical personnel.
SHELVES: the shelves were designed to bear a maximum load of 160 kg/sq.m. for shelves
9. PRESCRIPTIONS AND RESTRICTIONS
Keeping pharmaceutical products in the display case is strictly forbidden (fig.10).
Do not remove protections or panels when it requires the use of tools. IN PARTICULAR, DO NOT REMOVE THE ELEC-
TRIC CONTROL BOARD COVER AND THE SCREWS FASTENING SHELF LIGHTING PLUGS.
Do not expose the display case to atmospheric agents (fig. 15). DO NOT STEP on the cabinet bumper rail. DO NOT
STEP on the top of the cabinet and DO NOT LAY WEIGHTS on it (fig. 11).
Do not spill water directly or indirectly on the display case (fig. 13). Do not touch the equipment with damp or wet
hands or feet; do not use it while barefoot (fig. 14).
ANY OTHER USE NOT EXPRESSLY MENTIONED IN THIS BOOKLET MUST BE CONSIDERED AS HAZARDOUS.
THE MANUFACTURER ASSUMES NO RESPONSIBILITY FOR ANY DAMAGE RESULTING FROM IMPROPER,
INCORRECT OR UNREASONABLE USE.
10. ORDINARY MAINTENANCE
ATTENTION! BEFORE STARTING ANY MAINTENANCE OR CLEANING, DISCONNECT THE EQUIPMENT
FROM THE ELECTRICAL POWER SUPPLY USING THE MAIN WALL CUT-OFF SWITCH (fig. 19).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the working area is sufficient and
if necessary, use an additional source of light.
ANTIFOG FILM
Doors are provided with an antifog film laminated onto the internal side of the glass, and guarded by a protective
layer. The sides of the protective layer are slighty lifted in order for the layer to be easily removed for use. The pro-
tective layer must be removed after the doors have been fitted onto the cabinet and only when the cabinet has rea-
ched operating temperature, so that the antifog film may start to function immediately. This is reminded by the label
affixed on the protective film:" DO NOT REMOVE THE PROTECTIVE FILM UNTIL THE CABINET HAS REACHED THE
OPERATING TEMPERATURE".
The antifog film requires no special mainenance other than appropriate cleaning methods. In particular, do NOT use
moisturizing, abrasive, strongly acidic or caustic agents . This is reminded by a label affixed on the upper part of the
door: "DO NOT USE CLEANERS WHICH CONTAIN MOISTURIZERS, ABRASIVES,STRONG ACID, OR CAUSTIC SUB-
STANCES
CLEANING THE DISPLAY CASE
1) Every week clean the outer surfaces of the display case with mild soap or detergent in lukewarm water only.
Wipe carefully with a soft cloth. Never clean it using inflammable or scouring agents, alcohol, acetone or solvents.
NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS. Clean glass surfaces using glass-cleaning
QUM000065A
15

Publicité

loading