Operating Modes; Cleaning And Maintenance - MediaShop VibroShaper Mode D'emploi

OPERATING MODES

The resistance bands (19) can be used in both modes. To use them, slip the safety hooks
through the openings specially designed for them on the back of the platform, as shown
in figure 5. The resistance bands (19) can be used in both modes. To use them, slip
the safety hooks through the openings specially designed for them on the back of the
platform, as shown in figure 5.
Manual mode: Here, the user can set the length and tempo of their exercise, so that it's
tailored to their needs. When using manual mode, follow these instructions:
1. Plug the VibroShaper into a power socket and press the power switch (3) so that it is
in the ON position.
2. Press the "ON" button on the control panel (15) or the
3. Next, select the length of your exercise. It can be between one and 10 minutes. To increase the number of minutes, press the
button (11) on the control panel or the
panel (12) or the button on the remote control. The amount of time left in the exercise appears in the time display (8).
4. Start the exercise by pressing the button (17) on the control panel or the
5. You can now select the tempo of the vibration. The tempo settings range from 1 to 99. To select your desired tempo setting, press
the button (13) on the control panel or the
control panel or the
6. You can also select certain tempos quickly using the M button on the remote control. The M button allows you to jump to 90, 60
or 30.
7. To end the exercise at any time, press the button (18) on the control panel or the
finished the exercise, turn off the device by pressing the button (15) on the control panel or the
control.
Chart 1 shows our training recommendations for manual training.
Automatic Mode: The device follows a preset training programme, in which speed and time cannot be altered. When using this
mode the following instructions should be followed:
1. Plug the VibroShaper into a power socket and press the power switch (3) so that it is in the ON position.
2. Press the "ON" button on the control panel (15) or the
3. There are three different exercise programmes (P1, P2 and P3) available. Press button (16) on the control panel repeatedly or
the button on the remote control repeatedly until the programme you want appears on the programme display (8).
4. Chart 2 shows the exercise tempo of each programme depending on the length.
5. Once you've selected your chosen programme, start the exercise by pressing (17) on the control panel or
remote control.
6. To stop the device at any time, press the appropriate button (18) on the control panel or the
Once you've completed the exercise, turn the device off by pressing (15) on the control panel or the
control.

CLEANING AND MAINTENANCE

• Before cleaning your VibroShaper, you must make sure that the power switch is in the OFF position and that the cable has
been unplugged from the power socket.
• You can use a clean, dry broom or brush to remove dust from the device.
• The standing area can be cleaned with a damp cloth.
• Do not use corrosive agents to clean the device, because these could damage it.
• Clean the remote control with clean cloth.
• If the device is not being used for an extended period of time, put it back in its box and store it in a cool, dry place. You
should also take the batteries out of the remote control.
• If the device appears to have a defect, follow the instructions in the Troubleshooting section. If the problem persists,
please contact our customer service team.
12
button on the remote control. To shorten the time, press the button on the control
button on the remote control. To reduce the tempo, press the button (14) on the
button on the remote control.
button (1) on the remote control.
button on the remote control.
button on the remote control. Once you've
button on the remote control.
figure 5
button (1) on the remote
on the
utton on the remote control.
utton on the remote