Olimpia splendid DAFNE 65 Instructions Pour L'installation, L'emploi Et L'entretien page 41

ALARM SIGNALS
Any repairs must be carried out exclusively by the authorized service centre or by qualified personnel.
Warning: unplug the appliance before performing any operations.
ALARM DESCRIPTION
ALAr • Pellets hopper
Hot PEL temperature higher than
permitted.
• The fuel was not lit during
ALAr
no Acc startup and fire has not
been detected.
ALAr • Smoke evacuation stack
clogged.
no ASP
ALAr • Pellets hopper or
Sic tangential fan temperature
FAiL higher than permitted.
ALAr • Smoke evacuation stack
deP FAiL clogged.
• Smoke evacuation motor
ALAr
Fan FAiL not running.
ALAr • Fire no longer detected on
no FirE burner grate.
ALAr • The smoke temperature
Hot tEMP exceeded alarm value.
ALAr • Smoke probe broken.
Sond
Fumi
CooL • Appliance cooling.
FirE
• Room temperature not
ON 1...5
detected.
on t
ALAr If the glow plug breaks, while waiting for it to be repaired the start button can be pressed and the
no Acc pellets lit manually using a cube of fire lighter material.
F
CAUSE
• Upper or front air vents obstructed.
• Detection probe broken.
• Convection motor broken.
• Pellets not being fed.
• Glow plug broken.
• Fire not detected by smoke probe.
• Pellets cannot be lit.
• Stack clogged.
• Electrical connections interrupted.
• Pressure switch broken.
• Room in vacuum.
• Upper or front air vents obstructed.
• Temperature thermostat broken.
• Convection motor broken.
• Stack clogged.
• Electrical connections interrupted.
• Pressure switch broken.
• Room in vacuum.
• Electrical connections.
• Motor broken.
• No rotation.
• Pellets not being fed.
• Convection air outlet obstructed.
• Convection motor broken.
• Smoke probe position error.
• Excessive flame in furnace.
• Electrical connections interrupted.
• Probe broken.
• Voltage drop.
• Room temperature probe broken.
GB
REMEDY
• Check upper and front air vents.
• Replace probe.
• Check convection motor.
• Check for pellets in hopper and for
sawdust on bottom of hopper.
• Check auger.
• Check electrical connections.
• Replace glow plug.
• Check
connection of smoke probe.
• Improve fuel quality.
• Check stack.
• Check electrical connections.
• Replace pressure switch.
• Check fresh air intake.
• Check upper and front air vents.
• Replace thermostat.
• Check convection motor.
• Check stack.
• Check electrical connections.
• Replace pressure switch.
• Check fresh air intake.
• Check
connections.
• Check
connections.
• Replace motor.
• Check for mechanical blockage, try to
turn the motor manually.
• Check for pellets in hopper and for
sawdust on bottom of hopper (see
Cleaning the pellets hopper sect. 3.1).
• Check auger.
• Check upper and front air vents.
• Check convection motor.
• Check
connection of smoke probe.
• Clean the grate, leave to cool and
switch back on. If this problem
persists, the service centre or a
qualified
contacted.
• Check probe is correctly connected.
• Replace smoke probe.
• Wait for automatic restart.
• Check room temperature probe.
• Replace room temperature probe.
E
position, operation and
motor power supply
rev counter (encoder)
position, operation and
technician should be
3
3.4
41