Chicco Isofix Base Mode D'emploi page 15

To remove the child car seat
from the base:
Return the handgrip to the vertical
position (B) (Diag. 15) and release the
child car seat by pulling the release le-
ver whilst using the handgrip to lift it
upwards (Diag. 22).
Removing the base
Repeat the above process in the reverse
order.
Press the adjuster lever (L) on the sup-
port foot and shorten it all the way to
the end.
Lift the ISOFIX adjuster lever and pull
the base away from the backrest as far
as possible
Press the release buttons (H) to release
the ISOFIX connectors
Take the protective caps previously hid-
den away in the compartment and re-
place them on the ISOFIX connectors.
Push the ISOFIX system inside the base
as far as it will go.
INSTALLING AND REMOVAL
WITH VEHICLE 3-POINT SAFE-
TY BELT
Installation
1. Position the base on the chosen vehicle
seat, position it so that it touches the
vehicle seat backrest (Diag. 16).
2. Position the support foot (E) and use
the adjuster lever to fix it in place (L)
(Fig. 17).
3. Check the indicators (M and N) on
the foot to ensure it is fitted correctly.
When you can see the green indicator
(N), this means you have installed it
properly.
4. Pull the vehicle safety belt and con-
nect it to the relative buckle, threading
the horizontal abdominal belt through
the two slots (B) highlighted in blue
(Diag. 18).
5. Attach the child car seat onto the base
(in a rear-facing position) and push it
downwards until you hear it click into
place (Diag. 19).
6. The indicator on the side (D) will turn
green (Diag. 20) when the child car
seat is securely and correctly locked
on place.
7. Check that the child car seat is cor-
rectly fitted to the base by trying to
lift the front and rear sections.
8. Pull the diagonal car safety belt and
thread it through the relative slot,
highlighted in blue, on the back of the
child car seat backrest (Diag. 22)
9. Pull the belt as tight as possible
around the child car seat, without
leaving any slack and making sure it
is not twisted.
10. Turn the child car seat handlebar as
far as possible (B) against the vehicle
seat backrest (Diag. 21).
WARNING: NEVER INSERT THE
CAR SAFETY BELT IN ANY PO-
SITION OTHER THAN THOSE
INDICATED IN DIAGRAM 22.
To remove the child car seat
from the base:
free the diagonal safety belt from the
slot on the backrest, return the handle-
bar to the vertical position (A) (Diag. 21)
and release the child car seat by pulling
the relative lever whilst using the hand-
grip to lift it upwards (Diag. 23).
WARNING! After installing the child
car seat, ALWAYS check that the ve-
hicle safety belt is tightened properly
and the buckle clasps do not push the
belt out of the belt slot on the base and
does not interfere with the belt slots
themselves.
15