Plug Connector En 175301-803-A - SIKA VH Série Notice D'utilisation

VH / VK

3.1 Plug connector EN 175301-803-A

IMPORTANT
• To guarantee the type of protection IP 65 according to EN 60529, the connect-
ing cable has to have a sheathing diameter of between 4.5 and 10 mm.
• Furthermore, ensure that all gaskets
serted correctly.
 Loosen the central screw
connector  ( Fig. 1).
 Remove the central screw
 Open the core 
 Loosen the screwed cable gland M16x1.5 ( Fig. 3).
1 2
3 4
5
Fig. 1
 Insert the connection cable through the screwed cable gland
the rubber insert
 Connect the wires as shown in the connection diagram below ( p. 26, Fig. 7)
 Press the core 
 Put the central screw in the cable socket and tighten the screwed cable gland ( Fig. 5).
 Put the cable socket on the connector and tighten the central screw
9 10 5
8
Fig. 4
Technical changes reserved

M3x35 and disconnect the cable socket
 from the cable socket
of the cable socket with a screwdriver or similar tool ( Fig. 2).
6

into the cable socket ( Fig. 4).
into the cable socket
 ,  and 
 .
8
Fig. 2
 until it locks into place.
Fig. 5
Electrical connection
at the plug connector are in-

from the plug
Fig. 3
 , the pressure ring
 ( Fig. 6).
Fig. 6
 and
6
- 25 -