Compliance; Unpacking And Packing; Installing The Device - Kinetec Prima Advance Manuel D'utilisation

Compliance:

The device Kinetec Prima Advance™ complies with the standards of Directive 93/42/EEC, and bears the
EC mark.
The device Kinetec Prima Advance™ complies with the standards in force (IEC 60601-1-2) concerning
the electromagnetic compatibility of medical devices and IEC 60601-1 concerning electrical safety.
The device Kinetec Prima Advance™ meets the requirements of the Machinery Directive No. 2006/42/EC.

Unpacking and packing

Unpacking
When you unpack the machine, don't forget that you may need to pack
it up again. We recommend that you keep the packaging materials,
boxes and plastic bags.
Recommendations for plastic bags: do not put them over the head as
there is a risk of suffocation, and keep them out of the reach of children.
Be careful with small-sized pieces: they could be swallowed by a child.
Be careful with cables and wires: risk of strangulation.
Before using your machine you must move the foot plate into
its working position. (See page 7).
Your machine is ready to be connected to the power supply.
(See page 4).
Packing
To prevent any problems when the machine is
transported, only pack it using its original packaging.
- Set the leg support to 42cm
- Stop the unit at 5° of flexion.
- Move the foot plate back into its packing position.

Installing the device

The device Kinetec Prima Advance™ is designed to be used in hospitals, clinics, doctors' offices or in
private homes (rental).
The machine must be installed on a flat surface that is wide enough to accommodate the entire device
plus the other leg.
We recommend using the machine with a physiotherapy table, a healthcare bed, a bed or a bench.
We do not recommend the use of an air mattress.
Kinetec Prima Advance™
EN 3/11