Baofeng UV-5R Série Mode D'emploi page 18

Menu Name (Full Name) Setting
5 WN – Wide band WIDE [0] | NARR [1]
Narrow band
6 6 ABR - Display OFF [0] | X | 2 | 3 | 4 | 5 | 6 | 7 |
Illumination Time S | 9 | 10
7 TDR - Dual Watch, OFF [0] | ON [1]
Dual Reception
8 BEEP - Keypad OFF [0] | ON [1]
Beep
9 TOT - 15[0]-600[39] in 15 second
Transmission steps (TIMEOUT-15)/15=[n]
Time- out-Timer
10 R-DCS-Receiver OFF[0] see DCS Table in
DCS Appendix C
29
Description
Wideband (25 kHz bandwidth) or Narrow band
(12.5 kHz band-width).
Time-out for the LCD backlight, (seconds)
Monitor [A] and [B] at the same time. The display
with the most recent activity will be switched to
automatically.
Allows audible confirmation of a key press.
This feature provides a safety switch that limits
transmission time to a programmed value. This
will promote battery conservation by not allowing
you to make excessively long transmission, and
in the event of a stuck PTT button it can prevent
interference to other users as well as preventing
battery depletion.
Mutes the speaker of the transceiver in the
absence of a specific low-level digital signal. If
the station you are listening to does not transmit
this specific signal, you will not hear anything.
Menu Name (Full Name) Setting
11 R-CTCS - OFF[0] see CTCSS Table in
Receiver CTCSS Appendix C
12 T-DCS-Transmitter OFF[0] see DCS Table in
DCS Appendix C
13 T–CTCS- OFF[0] see CTCSS Table in
Transmitter Appendix C
CTCSS
14 VOICE- Voice OFF[0]| ENG [1]| CHI [2]
Prompt
15 ANI-ID-Automatic
Number ID
16 DTMFST-DTMF- OFF [0]: No DTMF Side Tones
Side Tone of are heard
Transmit code
DT-ST [2]: Side Tones are
heard only from automatically
keyed DTMF codes
DT+ANI [3]: All DTMF Side
Tones are heard
30
Description
Mutes the speaker of the transceiver in the
absence of a specific and continuous sub-audible
signal. If the station you are listening to does not
transmit this specific and continuous signal, you
will not hear anything.
Transmits a specific low-level digital signal to
unlock the squelch of a distant receiver (usually
a repeater).
Transmits a specific and continuous sub-audible
signal to unlock the squelch of adistant receiver
(usually a repeater).
Sets the radio's voice prompts to the language
set when pressing a button.
Displays the ANI code which has set by
computer software. This menu cannot be used to
change it. The ANI-ID is sent when the alarm is
activated and menu 32=CODE.
Determines when DTMF Side Tones can be
heard from the transceiver speaker.