Maintenance And Use - PowerPeak FET8265P Mode D'emploi

MAINTENANCE AND USE
• This device requires a regular check‐up to prevent physical injury. This means that bolts and nuts
should be frequently checked for cracks and sharp edges etc. should be frequently checked for cracks and sharp edges etc.
• Defective components must be replaced immediately. If this is not possible, the device must be put • Defective components must be replaced immediately. If this is not possible, the device must be put
out of order until the necessary repairs have been made. out of order until the necessary repairs have been made.
• Clean only with a damp cloth, do not use solvent cleaners. • Clean only with a damp cloth, do not use solvent cleaners.
• This product is intended for use in clean, dry conditions. You should avoid storage in excessively cold • This product is intended for use in clean, dry conditions. You should avoid storage in excessively cold
or damp places as this may lead to corrosion and other related problems. or damp places as this may lead to corrosion and other related problems.
IMPORTANT: place the device on a flat and stable surface. We recommend using a square piece of IMPORTANT: place the device on a flat and stable surface. We recommend using a square piece of
carpet or rubber underneath your device. This is to protect your floor from any damage due to carpet or rubber underneath your device. This is to protect your floor from any damage due to
prolonged use of the device. prolonged use of the device.
Resistance control Resistance control
1. The resistance can easily be adjusted with the tension knob (No. 36). The resistance will increase 1. The resistance can easily be adjusted with the tension knob (No. 36). The resistance will increase
when the knob is turned to the right and decrease when the knob is turned to the left. when the knob is turned to the right and decrease when the knob is turned to the left.
2. The maximum resistance can be increased or the minimum resistance can be decreased by adjusting 2. The maximum resistance can be increased or the minimum resistance can be decreased by adjusting
the tension belt. The resistance will increase when the belt is tightened and decrease when the belt the tension belt. The resistance will increase when the belt is tightened and decrease when the belt
is loosened. Attach the tension belt firmly after each adjustment. is loosened. Attach the tension belt firmly after each adjustment.
3. The tension belt can become loose through extensive use. Follow the instructions above to fasten it. 3. The tension belt can become loose through extensive use. Follow the instructions above to fasten it.
physical injury. This means that bolts and nuts
26