Using The Flyscreen - Dometic FlyTec FT100 Instructions De Montage Et De Service

Using the flyscreen

5.5 Completing installation
Riveting the cassette profile (fig. 7, page 6)
➤ Put all the blind rivets (4 x 8 mm with stainless steel mandrel) through the
drill holes and rivet the components using a hand riveter.
Tensioning the guide cables
➤ Secure the the deflection screw M4 (fig. 8 1, page 6) on the skirting
board.
➤ Secure the the deflection screw M5 (fig. 8 2, page 6) on the upper guide
rail.
➤ Tension the guide cable on the deflection screws and on the upper guide
rail (fig. 8, page 6).
The tension of the cables affects the guidance and smooth running of the
handle strip. By changing the tension of the upper and lower cable, you can
adjust the parallel orientation of the handle strip to the magnetic plate.
➤ Secure the safety clip to the deflection screws M4 and M5 using one
screw in each case (M2.5 x 6 mm).
6 Using the flyscreen
A
NOTICE! Beware of damage!
The sliding door of the vehicle may be closed only when the fly-
screen is fully open.
Closing the flyscreen
➤ Pull the handle strip on the flyscreen to close the flyscreen (fig. 9,
page 7).
✓ The magnetic plate holds the flyscreen closed.
Opening the flyscreen
➤ Pull the handle strip on the flyscreen to open the flyscreen (fig. 9,
page 7).
22
Dometic FlyTec FT100
EN