Installing the refrigerator
Refrigerator height (A)
Refrigerator width (B)
Refrigerator depth (C)
(excludes control knob
5 mm)
Recess height (H)
Recess width (W)
Recess depth (D)
4.2
Installing the condensate drain
I
NOTE
• Condensation can form inside the refrigerator due to frequent door
opening, incorrectly stored food or food that is stored when it is too
warm.
• Condensation must be drained with a constant slope.
Install the condensate drain as follows:
➤ Run the condensation water hose from the refrigerator through an opening in the
floor which goes outside.
4.3
Connecting the power supply
A
NOTICE! Damage hazard
• The electrical installation and repairs may only be performed by a
specialist in accordance with the applicable national regulations and
standards.
• To avoid voltage loss and therefore a drop in performance, the cable
should be kept as short as possible and should not be interrupted if
possible. For this reason avoid additional switches, plugs or power
strips.
• Before connecting check whether the operating voltage and the bat-
tery voltage correspond (see type plate).
16
RCS10.5(S)(T)
821 mm
523 mm
555 mm
829 mm
528 mm
558 mm
RC(S)(L)(D)10-Series
RCS10.5X(S)(T)
821 mm
523 mm
610 mm
829 mm
528 mm
613 mm
EN